Skip to content
Get a quote

Furniture Glossary

Tolerance

Tolerance is the acceptable range of deviation in a dimension, setting limits for how well furniture parts fit and for visible gaps.

Tolerance is the acceptable range by which the size of a part may deviate from its designed value. No manufacturing method gives an exact dimension, and tolerance keeps the deviation within limits that will not spoil assembly or appearance. For example, a few tenths of a millimetre in a door width is acceptable, but the same deviation becomes visible in the gap beside the neighbouring door.

In furniture, tolerance matters in three places. The first is part production, where sizing, drilling and edge banding tolerances are commonly held to tenths of a millimetre. The second is assembly: door gaps, drawer clearances and the allowance between carcass and wall must be consistent. The third is the room itself. Because walls and floors are not perfectly flat, the allowance left between a carcass and the wall, usually a few millimetres, is a site tolerance covered with a filler strip, skirting or scribe piece.

Wood and boards expand with moisture, so dimensions must take this movement into account, and in humid conditions a small movement allowance is left between parts. Tolerance values are shown on the technical drawing and checked by measurement during production. A check measurement shows whether the deviation has gone outside the limit. Since tight tolerance can increase cost and time, it is kept tight where needed and reasonable elsewhere.

Related applications

Joiner planing solid wood on a workbench, with shavings scattered around

Manufacturing

We make the approved design in our own factory to the measurements taken at the survey, and carry out cutting, edge banding, drilling and packing to the approved cutting list.

Fitter installing a wooden cabinet door with a cordless drill

Installation

We install the furniture made in the factory on site, align it to the wall and floor, and hand it over with door, drawer and hardware adjustments done.