Veneer pressing is the process of gluing thin wood veneer or decorative laminate to a substrate, usually MDF or chipboard, and clamping it in a press. Many furniture surfaces that need a real-wood look without the cost and movement of solid wood are made this way. Done correctly, the veneer bonds into the surface as one piece.
The process runs in a set order. The substrate is sanded and cleaned, glue is spread evenly on the board or the veneer, the veneer is laid on, and the assembly goes between press platens. Veneer is usually applied to both faces so one side does not pull the board into a curve. Hot presses cure the glue quickly, while cold presses need longer. For curved parts, a vacuum membrane press is the usual choice.
Pressure, temperature and time are set according to veneer thickness and the glue used. Too much glue can bleed through and stain the surface, and too little leaves bubbles. Matching the grain carefully gives a consistent look across doors and panels. The veneered board then rests before it is sized and edge banded. If lifting or bubbles appear, the glue and humidity conditions should be reviewed.


