
Edge banding is the application of a thin strip to the exposed cut edges of chipboard or MDF parts. The strip gives the edge a finished look and keeps moisture from entering the core of the board. An unbanded edge swells and chips over time and is difficult to keep clean.
Edge bands are usually made of PVC, ABS, melamine or real wood veneer. Thickness typically ranges from about 0.4 to 2 mm, with thinner tape used on interior surfaces and thicker tape on door and worktop edges. An edge banding machine cleans the edge, applies hot-melt glue, presses the tape on, trims the excess and rounds the corners. Laser or hot-air systems leave an almost invisible joint line between the tape and the board.
When choosing, check that the colour and pattern of the band match the board surface. Lifting edges are generally caused by poor glue or a dirty edge. In humid areas such as bathrooms and kitchens a fully sealed joint is especially important. For care, avoid harsh chemicals and steam cleaners, which can soften the glue line and shorten the life of the band.


