A gas strut is a support made of a cylinder holding compressed gas and a piston rod. The gas pressure pushes the rod outwards, and this force balances the weight of the flap so that it lifts easily and stays in the position chosen. In furniture it is used on flaps, lift-up cabinet mechanisms, bed bases and chest lids.
The strut is fixed at each end to the carcass and the flap with end fittings. Lengths, force ratings and fitting styles differ, and the force is usually stated in newtons. Some models contain oil that damps the end of the stroke, helping the flap to stop gently. Lockable types let the flap be fixed at a chosen angle.
When selecting one, the weight of the flap and its centre of gravity relative to the carcass must be taken into account, because a strut that is too strong will throw the flap up and one that is too weak will not hold it. The horizontal and vertical positions and the fixing points should be set out by measurement. A working strut should not be exposed to excess heat or knocks, and a spent strut should never be cut or punctured. If the gas gradually leaks, the flap will sink, and the strut is then replaced with an equivalent part.


