A mitre joint joins two parts at a corner by cutting both ends at an angle, most often 45 degrees, and gluing them together. This forms a 90-degree corner and hides the cut end from view. It is used in wooden frames, mouldings and trim, worktop and door edges, and in thick-looking table and counter edges.
The main advantage of a mitre is that the grain and pattern appear to run continuously around the corner. The drawback is that the joint face consists of short end grain, which holds glue poorly on its own. For this reason, mitred corners are often reinforced with biscuits, dowels, keys or splines. A precise mitre needs the saw and angle to be checked carefully, since even half a degree of error opens the corner.
On veneered or laminated boards, boxes folded with mitre joints need no edge banding and show a clean, unbroken surface, a method sometimes called mitre folding. On wide surfaces, however, parts move with moisture, and small gaps may appear at the corner over time. Well-dried wood and the correct glue are therefore important, and the clamping time recommended by the glue manufacturer should be followed.


