Multi-spindle drilling, also called line boring, opens connection points such as dowel holes, cam fittings, hinge cups, shelf-pin holes and runner screw holes in several places at once. Dozens of holes are drilled in one pass, which saves time and keeps the spacing between holes constant. The margin for error is far lower than marking and drilling by hand.
The 32 mm system is widely used. Holes in side panels are set at 32 mm intervals so shelf pins, hinge plates and drawer runners all line up in the same pattern. Horizontal spindles drill dowel holes into panel edges, while vertical spindles drill pin and hinge holes into the face. CNC machining centres can produce the same holes more flexibly from a program.
Hole depth, diameter and distance from the edge must be set correctly. A hole that is too deep may show through the surface, and one that is too shallow weakens the joint. Dull bits cause chipping, so they are replaced regularly. When the drilling plan matches the cutting list and technical drawing, parts assemble without extra adjustment.


