
Panel sizing means cutting standard sheets of chipboard, MDF or plywood, commonly around 2800 by 2070 mm, into the exact parts a project needs. It is the first factory step in furniture manufacturing, and the accuracy of every later operation depends on it. The dimensions come from the cutting list prepared from the technical drawings.
Workshops usually use horizontal or vertical panel saws. A small scoring blade first cuts the underside of the board so the main blade does not chip the edge, and the main blade then makes the full cut. Optimisation software arranges the parts on each sheet to keep waste low. On veneered or grained surfaces, the direction of the grain is also respected in this layout.
After sizing, parts are labelled and moved on to edge banding and drilling. Consistent dimensions, within a fraction of a millimetre, give doors even gaps once assembled. A dull blade leaves chipped or rough edges, so blades are serviced regularly. Boards should also be stored flat and dry before cutting, since moisture and warping make accurate sizing harder.


