A rebate joint is made when stepped cuts, usually half the thickness of the material, are cut along the edges of two wooden parts and overlap each other. The step is called a rebate (or rabbet). The parts are fixed with glue and, where needed, screws. Compared with a plain butt joint, the glue area is larger and the step stops the parts from sliding against each other.
In furniture it is mostly used for back panel grooves in cabinet carcasses, drawer bottoms, door frames and glass or mirror seats. Seating the back panel in a rebate hides the edge of the panel from outside and helps keep the carcass square. A rebate can be cut on one edge, or on both parts of a frame corner. It can be made with a router, a table saw or a CNC machine.
Rebate depth and width are set according to the thickness of the parts, and a depth of about half the thickness is common. A rebate that is too deep weakens the piece. During assembly, dust and shavings should be cleaned out of the rebate so the glue grips fully. A neat joint line from outside is a good sign of workmanship. In humid environments, a small gap is often left in the rebate to allow for wood movement.


