
Chipboard, also called particleboard, is made by mixing wood chips and sawdust with resin and pressing them into a flat panel under heat. Most boards have coarser particles in the centre and finer particles at the faces, which gives a smoother surface. It is the most widely used and economical carcass material in furniture making.
It is supplied raw or already faced with melamine, HPL or real wood veneer. Thicknesses of roughly 16 to 25 mm are typical. Moisture-resistant and low-emission grades are available. Density and screw-holding strength vary with the quality of the board.
Common uses are cabinet carcasses, shelves, bed bases, office desks and partition panels. On broad flat surfaces it is stable and reliable, although work that needs deep profile routing is better done in MDF.
When choosing, look at density, edge strength and emission class. Water and prolonged damp make the particles swell permanently, so wet areas call for a moisture-resistant grade and fully sealed edges. Avoid very long unsupported shelf spans, since they can sag in the middle over time.



